| Vibration Sensor Stud Model 191.01 |
|
Stud, non isolated Mounting stud with options for: M5, M6, 10-32 UNF2A, 1/4 28 UNF 2A sensor thread M5, M6, M8, 10-32 UNF2A, 1/4 28 UNF 2A structure thread AISI 303, 316L, Inconel X750 material Datasheet 191.01 This is the most usual method of accelerometer mounting. These studs are detachable, permitting rapid, low cost replacement. They are used by most accelerometer manufacturers but they are not fully compatible due to the shoulder diameter and the thread length.You should not use ordinary machine screws. They lack a flange or shoulder and might bottom in the accelerometer degrading his dynamic response. Comments
(0)
|
Subscribe to this comment's feed
Show/Hide comments
Show/Hide comment form